Highsider License Plate Holder Akron-RS Without Tail Light in Black for several Triumph models

The HIGHSIDER pro Akron-RS licence plate holder without a rear light replaces the original holder on various Triumph models. Its design follows the lines of the bike and lets you set the plate in your preferred position.

It is made from 2 mm laser-cut steel sheet with a weather-resistant black powder coating. The tilt angle is continuously adjustable, with an additional locking screw to hold the setting.

• Indicators: width-adjustable mounts with 10 mm side-slotted holes, allowing fitting without disconnecting the wiring.
• Reflector: E-approved and adjustable on a slider.
• Wiring protection: rubber membrane grommets cover sharp-edged cable passages.
• Plate support: two rubber washers help reduce vibration, while a rubber stop supports the lower edge.
• Plate fit: suitable for European number plates, with slotted holes to make fitting easier.
• Weight: 1076 g.

This model-specific holder fits the original mounting points without drilling or cutting.