Puig 4298O 4-output LED Indicator Resistors

Puig resistors for LED indicators help correct the flash rate when you fit LED indicators to your motorcycle. They are intended for situations where a change in electrical consumption alters the indicator timing.

If you replace a conventional indicator bulb, keep to the same wattage. If you switch to LEDs, check the flash rate first: not every motorcycle will need a change to its indicator circuit.

• Bimetallic relay: its flash rate depends on the current flowing through the circuit, so changing the indicators may affect it.
• Electronic relay: its flash rate does not depend on current, so the change should not normally affect the timing.
• Installation: the resistor solution requires a parallel connection on each side, left and right.
• Configuration: the manufacturer specifies different resistors depending on whether two or four indicators are replaced.
• Material and finish: gold-coloured aluminium.
• Weight: 70 g.

Replacing the relay is another option if your motorcycle allows it; first identify its location and number of pins. Some motorcycles have no dedicated indicator relay, and changing just one may not solve the issue if several are involved.