Puig Light 9557N Black LED Turn Signals

The Puig Light LED indicator set in black updates your motorcycle’s signalling with a different look from the original indicators. LED technology draws less power than incandescent bulbs, which needs to be taken into account when adapting the electrical installation.

If your motorcycle uses a bimetallic flasher relay, the change in current draw can affect the flash rate; with an electronic relay, it should remain unchanged. To correct the rate, you can fit a resistor in parallel on each side, selected according to how many indicators you replace, or install a suitable replacement relay after checking its location and pin count.

• Material: polypropylene housing.
• Lens: smoked.
• Weight: 100 g.
• Approval: E4-50R-002340; the manufacturer states that these indicators are approved for Spain’s ITV vehicle inspection.

Before fitting, bear in mind that resistors prevent the hazard lights from working correctly on most models, and some motorcycles do not allow relay replacement; where several relays are involved, replacing just one may not solve the issue. To check the actual flash rate after connection, switch the ignition off and back on before operating the indicators.