Support de plaque Highsider Akron-RS sans feu arrière coloris Noir pour Kawasaki ER-6 F/N (12-16)

The HIGHSIDER pro Akron-RS number plate holder for Kawasaki replaces the original bracket while following the lines of the bike. This version without a rear light uses the original mounting points, so there is no need to drill or cut the bike.

It is made from 2 mm laser-cut steel sheet. The black powder coating is weather-resistant.

• Angle: continuously adjustable, with an additional screw to lock the chosen position.
• Indicators: width-adjustable brackets with 10 mm holes slotted at the side, allowing fitting without disconnecting the wiring.
• Rear reflector: approved and adjustable on a slider to suit different European number plate formats.
• Wiring protection: rubber membrane grommets protect cables where they pass through sharp-edged openings.
• Number plate mounting: slotted holes make fitting easier, while two rubber washers help reduce vibration and a rubber stop supports the lower edge.
• Weight: 969 g.

Mounting parts and fitting instructions are included for installation on your bike.