Puig Chip 9942N Black LED Turn Signals
Buy this and earn 39 AC Coins (€0.39) for your next purchase. Account holders only · create yours.
The Puig Chip LED indicators in black replace your motorcycle’s original indicators to signal changes of direction. They provide a turn signal function only.
Switching from incandescent bulbs to LEDs reduces current draw, which can change the flash rate with a bimetallic relay. An electronic relay should keep the frequency unchanged.
- Lens: transparent, measuring 27x18 mm.
- Material: polypropylene.
- Weight: 50 g.
- Approval: E8-50 R-0007114; the manufacturer states that these indicators are approved for Spain’s ITV vehicle inspection.
- Resistor adjustment: fit one resistor in parallel on each side. Puig specifies 4298O when replacing all four indicators, or 5873O when replacing two, one on each side. Wiring diagrams are supplied with the resistors, but on most models this approach prevents the hazard lights from working correctly.
- Relay alternative: identify the relay’s location and pin count before replacing it; this usually preserves hazard light operation. Replacement is not possible without a dedicated indicator relay, and changing just one may not resolve the issue when several relays are involved.
Check the flash rate after installation. If you connected the LEDs with the ignition on, turn the key to “off” and then back to “on” before activating the indicators to check their actual flash rate.
| Reference | 9942N |
|---|---|
| Color | Black |
| Homologation | Yes |
| Length | 24mm |
| Width | 16mm |
| Brand | Puig |
| Technology | LED |
| Lens colour | Transparent |
| EAN13 | 8436571718440 |